Table of Contents
Advertisement
Camera Recording
Simple Recording
Before you begin...
* Connect the Palmcorder to a power source.
* Insert a cassette with record tab (see page 10).
1 Set the POWER
switch to CAMERA.
Built-In Lens Cover opens.
EVF
Record/Pause
mode.
2 With the Viewfinder Eye Cup up to
your eye, adjust the Vision Adjust-
ment Control to your eyesight.
3 Slide the TAPE SPEED Selector
to SP or SLP (refer to page 10).
4 ове RECORD/PAUSE to start
recording.
The Tally Lamp and RECORD/PAUSE
are lit during recording.
Note:
* Do not leave the Palmcorder with the EVF
aimed directly at the sun as this may cause
RECORD
damage to the internal parts of the EVF.
Vl
Press RECORD/PAUSE again to
pause recording.
Set the Power switch to OFF after
recording is finished.
• To remove the cassette
In Record/Pause mode, slide the TAPE EJECT
switch (refer to page 10).
bright objects, or bright lights, a vertical bar
may appear in the picture. This is a normal
characteristic of the CCD pick-up device. Try
to avoid this when possible.
20
Advertisement
Table of Contents
