Camera Recording
View recording scene on EVF or LCD
(Liquid Crystal Display) monitor.
Rotating partially open LCD
monitor may block cassette door
and damage Camcorder body.
Note:
• When Camcorder is aimed at excessively
bright objects, or bright lights, a vertical
bar may appear in the picture. This is
normal for the CCD pick-up. Try to avoid
this when possible.
• Using LCD monitor reduces battery
operation time. Return LCD monitor to
locked position when not in use.
14
Before you begin...
• Connect Camcorder to power source.
• Insert cassette with record tab (page 10).
1
Press LCD-OPEN
to unlock the LCD
monitor.
Swing LCD monitor fully
open and adjust viewing angle.
• If you want to record using EVF, close
and lock LCD monitor.
—
PAUSE
V-
_
EVF or LCD Monitor
(Record/Pause mode)
Set POWER to
CAMERA.
Lens Cover opens.
Power Lamp lights.
• Be sure POWER
is fully turned to
CAMERA position.
• EVF or LCD monitor turns on/off by the
POWER switch.
• EVF shuts off when LCD monitor is
opened and turns back on when LCD
is closed.
• Both EVF and LCD monitor turn on
when LCD is at 180° (see above left).
This allows both you and the subject to
view the recording.
LCD
: Turn BRIGHT control to
monitor
adjust LCD monitor
brightness level.
EVF
: Look into EVF and adjust
VISION ADJUSTMENT to
your eyesight.
Hold down TAPE SPEED
for about
1
second to change tape speed to SP/SLP
(page 10).
Press RECORD/
PAUSE
to start or
pause recording.
Set POWER to
OFF
when finished.
Tape speed
EVF or LCD Monitor
(Record mode)
• To remove the cassette,
slide the TAPE
EJECT switch (page 10).
WARNING:
• Do not leave the camcorder with the EVF
aimed directly at the sun. This may cause
damage to the internal parts of the EVF.
For assistance, please call: 1-800-211 -PANA(7262) or send e-mail to: consumerproducts@panasonic.com