Configuring The Network Interface - Epson pro4880gd Printer Manual

20 | Setting Up the Printer On a Network
Note: You can also
configure the network port
using the EpsonNet
Configuration Utility that
installs with your printer
software.
Note: If you don't know
which setting to use, see
your network administrator
for help configuring the
printer's IP settings.

Configuring the Network Interface

1. Make sure that the printer is turned on and the LCD displays READY.
2. Press the
Menu
printer's menu system.
3. Press to highlight
4. Press then
Menu
5. Press . An asterisk appears next to
Menu
selected.
6. Press then to highlight
7. Press and then
Menu
configuration settings:
: Select this setting if your network uses a DHCP server to
• AUTO
configure your network devices' IP settings automatically.
: Select this setting if you would like to configure the
• PANEL
printer's IP settings manually.
8. Press . An asterisk appears next to the setting you selected.
Menu
9. Press to go back. Then do one of the following:
If you selected
•
pause button to exit the printer menu. Then continue with step 14.
If you selected
•
with step 10.
10. Press to highlight
address.
11. Press or to change each octet value, then press
the next octet. When you have changed the value of the last octet, press
then . The LCD displays
Menu
display the subnet mask.
button on the printer's control panel to enter the
NETWORK SETUP
to highlight
ENABLE
GET IPADDRESS
to choose one of the following IP
as the IP ADDRESS SETTING, press the
AUTO
as the IP ADDRESS SETTING, continue
PANEL
, then press
IP Menu
SM
20
, then press
Menu
.
to show that it's
ENABLE
.
. The LCD displays the IP
to select
Menu
. Press again to
Menu
.