Adjust The Digitizer Table; Adjust The Monitor Table; Adjust The Monitor Position; Adjust The Keyboard Position - Intergraph ImageStation ZIII Installation And Use Manual

16

Adjust the Digitizer Table

Adjust the height of the digitizer table so that your arms are comfortably at your side when
using the two-handed controller or keyboard.
Your elbows should be bent at approximately 90 degrees when your hands are resting on the
two-handed controller or at the keyboard. If the table is at the lowest setting, you may need to
raise the chair height to place your hands at a proper height. A footrest may be required if
your feet do not rest flat on the floor.
To adjust the digitizer table:
1. Move the digitizer table out from under the monitor table when using the entire digitizing
area.
2. Lock the casters on the digitizer table to prevent it from moving unintentionally.

Adjust the Monitor Table

The monitor table should be centered along the back edge of the digitizer table so that the
monitor screen will be directly in front of you.
Adjust the height of the monitor table so that the center of the monitor screen is slightly below
eye level.

Adjust the Monitor Position

The monitor should be placed on the monitor table. The monitor base should be centered on
the table top to evenly distribute the weight of the monitor on the table. This position allows
enough room for the placement of the keyboard in front of the monitor, if desired.
NOTE Avoid placing the monitor so that it reflects glare from room lights.

Adjust the Keyboard Position

The keyboard can be placed in any position on the digitizer table, or on the front of the
monitor table, according to your preference.
To use the keyboard:
1. For periods of infrequent keyboard input, place the keyboard on the front edge of the
monitor table in front of the monitor.