Table of Contents
Advertisement
8
4
Completing the Installation
You can adjust the monitor and digitizer tables and the Cyborg chair to meet the needs of the
individual user. Refer to Chapter 7 "Adjusting System Ergonomics" in this document.
Arrange the furniture with the monitor table centered behind and over the digitizer table.
Center the Cyborg chair in front of the digitizer table.
CAUTION
Do not use auxiliary power outlets or extension cords when connecting to AC power.
To connect the remaining power cords:
1.
Attach one end of the power cord to the monitor, and the other end to an AC power outlet.
2.
Attach one end of the power cord to the TDZ workstation, and the other end to an AC
power outlet.
3.
Attach the power cord from the Altek digitizer controller to an AC power outlet.
4.
Connect the interface PEM power cord to an AC power outlet.
To verify the installation:
1.
Place the interface PEM power switch in the ON ( | ) position.
CAUTION
After installation, the 3-position interface PEM power switch should always remain in the ON
( | ) position.
2.
Verify that the two-handed controller is on the active area of the digitizer table.
NOTE
You should remove the two-handed controller from the digitizing surface when using the
system's mouse. Otherwise, the cursor may snap back to the original location as defined by
the two-handed controller.
3.
Verify the proper Altek digitizer controller connection to the workstation.
NOTE
The system must be powered up with the two-handed controller on top of the active area
(center) of the digitizer table for proper operation.
4.
Turn on power to the monitor, and then turn on power to the TDZ workstation base unit.
5.
Verify that the green LED is lit on front of the interface PEM to ensure its power switch is
in the ON ( | ) position.
Maintain the Equipment
To maintain the equipment:
1.
Each week, clean the bottom of the two-handed controller with a cloth or paper towel
dampened with a glass cleaning solution.
Advertisement
Table of Contents
Need help?
Do you have a question about the ImageStation ZIII and is the answer not in the manual?
Questions and answers