Casablanca C3443001 AT0209 Owner's Manual page 14

Step 5d. Remove the ceramic wire nuts from the
wires and set aside for use in the next two steps.
• Attach the WHITE wire on the socket plate to the
WHITE wire coming from the bottom of the motor.
Secure with a ceramic wire nut.
• Attach the WHITE wire on the socket plate to the
BlACK wire with white stripe coming from the
bottom of the motor. Secure with a ceramic wire
nut.
Step 5e. Carefully tuck in the wires so they do not get
pinched. Align the three holes on the socket plate with
the screw holes on the switch housing. Insert three
socket plate screws (Pack E) and tighten until secure
using the screwdriver as shown in Figure #1.
Install Halogen Bulb
Step 6a. Insert one end of the halogen bulb into the
socket. Push the end of the socket, then insert the
other side of the halogen bulb into the socket. as
shown in Figure #2.
Step 6b. Install the glass shield by pushing it into
place with the clips on the light socket as shown in
Figure #3.
CAUTION:
The halogen bulb is very delicate and should
not be handled with bare hands. After
removing it from the box, grasp it gently by
the plastic covering or a soft cloth.
noTE: In compliance with uS Federal Energy
Regulations, this ceiling fan contains a device that
restricts the light fixture to a maximum of 190 watts.
Exceeding that limit or the marked limit on this product
may result in a fire hazard or improper operation.
14
socket Plate
GlAss iNsTAllATioN
lightbulb
sockets
halogen
lightbulb
halogen
lightbulb
lightbulb
shield
Ceramic
Wire Nuts
socket Plate
screws
Figure #1
Figure #2
Figure #3