The Battery And Ac Adapter; Paper Control Switches - Epson P-80 User Manual

PAPER SURFACE switch —
to improve the print quality on standard paper. Push this lever toward
the front when using coarse paper; push it back when using smooth or
thermal paper.
Note: You have to set the paper surface switch with the power OFF
for the change to take effect.
Paper-out sensor
The P-80 is equipped with a device that warns you when the printer
is at the end of the paper. When your paper reaches the end, the ON
LINE light goes off and printing stops.
To resume printing, place another sheet of paper into the printer,
and press the ON LINE switch. If you do not want to resume printing,
turn the power OFF and back ON again. Each time the printer is
turned ON, it reinitializes-resets to its settings at start up.

The Battery and AC Adapter

Note: Charge the battery with the AC adapter before using your
printer for the first time. To do this, follow the instructions
given below for charging the battery.
The P-80 will print approximately 60,000 characters (or 30 pages on
8½ by paper with 2,000 characters each) on a fully charged battery.
11
Figure 2-2. Paper control switches
This switch adjusts the print head speed
17