Table of Contents
Advertisement
Once you've confirmed that you've received all the necessary parts,
remove the sheet of paper wrapped around the printer's platen (the
black roller). This sheet of paper protects the paper-out sensor during
shipping, so be sure to replace it if you ship or store your printer.
Tilt the dust cover up and remove the two foam pads on the under-
side of the cover. (The pads protect the pin-feed holders on the tractor
unit during shipping, so be sure to save them.)
There is also a clear plastic overlay on the control panel to protect
against scratching and discoloration. It's up to you whether you want
to remove the overlay or leave it on.
Installing the paper feed knob
Before proceeding, you should install the paper feed knob. To
install the knob, simply push it onto the shaft on the right side of the
printer, as shown in Figure 1-2. The shaft has one flat side that must be
matched with the flat side of the hole in the knob.
Figure 1-2. Installing the paper feed knob
2
Selecting the Right Location
The most important consideration in choosing a location for
your printer is that it be close enough to connect a cable to your com-
puter. But also keep the following tips in mind:
1-2
Advertisement
Table of Contents
