Setting Up The Channel List; Using Initiaj Setup - Sony KDP-51WS655 Operating Instructions Manual

Setting Up the Channel List
After you finish cormecting the TV, you need to run the Initial Setup
feature, which automatically creates a list of aw_ilable analog and
digital channels. The Initial Setup screens appear when you turn on
your TV for the first time after hooking it up.
Usir_g Jnftfat Setidp
[] if you are usinga
CabbCARD, A uto Programis
disabbd for the CABLE input
Torun Initial Setup
I
Press POWER t o turn on the TV.
The Initial Setup screen appears.
2 Using the remote control, move the highlight to the desired
language, then press _ to select that language.
3 The next screen instructs you to connect your cable/antenna.
Check that you've connected your signal source correctly.
To start Auto Program, highlight Yesand then press _.
Auto Program automatically creates a list of receivable analog
and digital channels. Auto Program may take 50 minutes or more
to complete. A progress bar is displayed while the channel list is
being created.
The lowest numbered channel is displayed.
Torun Auto Program again at a later time
[] Use the Auto Program feature as described on page 89.
Toadd individualdigital channels
Use the Digital Channel feature as described on page 89.
Toreset the TVto factory settings
1
Press POWER to turnon the TV.
2 Hold down RESET on the remote control.
3 Press POWER on the TM
4 Release RESET. (The TV will turn itself off, then back on.)
43