Connecting A Dvd Player With A/V - Sony WEGA KLV-21SR2 Operating Instructions Manual

Installing and Connecting tile TV
Connecting a DVD Player with A/V Connectors
Use this hookup if:
• Your DVD player does not have component (Y, PB, PR) jacks.
Tip
if your DVD player has component video output connectors, for best picture quality, use the
connection described on page 16.
Disconnect all power sources before making any connections.
1 Using an AUDIO cable, connect the DVD player's AUDIO OUT jacks to
the TV's AUDIO IN jacks.
2 Using an S VIDEO cable, connect the DVD player's S VIDEO jack to
the TV's S VIDEO jack.
Rear of TV
S VIDEO cable 2
(not supplied) ...............
AUD,Ocab,o
oot
iio j
[@®®
DVD player
I Aunm
L_ ..........
Note
To watch the pictures input from the S VIDEO input jack, set "Auto YC" to "On" in the _1_
(Setup) menu (See page 12).
Tips
• You can also use the VIDEO 2 IN jacks to connect your DVD player.
• To take advantage of the Wide Screen Modes, set the TV's aspect ratio to 16:9 on your
DVD player. For details, refer to the operating instructions supplied with your DVD player.
• Use TV/VIDEO on the remote control to switch to the DVD player input.
• If your DVD player is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of
the S VIDEO cable.
17