Connecting A Vcr And Cable Tv - Sony WEGA KLV-21SR2 Operating Instructions Manual

Installing and Connecting tile TV
Connecting a VCR and Cable TV
12
Use this hookup if:
• You have cable TV that does not require a cable box.
Disconnect all power sources before making any connections.
1
Connect the CATV cable to the VCR's IN jack.
2 Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack
to the TV's VHF/UHF jack.
3 Using AUDIO and S VIDEO cables, connect the VCR's AUD10 and S
V1DEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks.
75-ohm coaxial
cable (supplied)
VCR _2
l SV,DEO0eb,e
(not supplied)
t
AUDIO cable
(not supplied)
Rear of TV
75-ohm coaxial L._ _ ]_i
cable (supplied) _--
I
II _ Ii
SWDEO
................
_TY_TTT_
I li
ViD O( o,,ow) .......... n
AUD'°-L (wh'I°)-°°;"-__TI"RT_ I li
AUDIO-R(red "' '_ ' " Q
1
©
Note
To watch the pictures input from the S VIDEO input jack, set "Auto YC" to "On" in the
(Setup) menu (See below).
Tips
•
YOUcan also use the VIDEO 2 IN jacks to connect your VCR.
• If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S
VIDEO cable.
When connecting both VIDEO OUT and S VIDEO OUT
You can select the jack the TV receives the input signal from on the menu screen.
The TV is factory set to receive S V1DEO input signals.
1 Press TV/V1DEO repeatedly to select VIDEO 1 IN.
2 Press MENU.
3 Press t/$ to select _ (Setup), then press (!).
4 Press t/$ to select "Auto YC," then press (_D.
5 To watch the pictures input from the S VIDEO input jack:
Press t/$ to select "On," then press (i).
To watch the pictures input from the V1DEO input jack:
Press t/$ to select "Oft." then press (i).
6 Press MENU to exit the menu screen.