Adjusting The Cutter Installation - Brother HE-800B Instruction Manual

9. STANDARD ADJUSTMENTS

9-6. Adjusting the cutter installation

67
Lowest
position
Top of needle plate
Lowest
position
Top of needle plate
1.5 – 2.0 mm
0.3 mm
1. Install the cutter with the screw (1) so that the tip A of
the cutter blade is aligned with the top of the needle
plate when the cutter is pressed down by hand to its
lowest position.
* If using the flat cutter (2), install with the screw (1)
so that there is a clearance of 1.5–2.0 mm between
the cutter and the top of the needle plate.
NOTE:
・ When the cutter is driven by the solenoid, the
movement will be approximately 2 mm greater
than that shown in the illustration.
・ If the cutter does not cut properly, the cutter may
get stuck in the material and not return. If this
happens, replace or sharpen the cutter.
3979Q
2. Loosen the two screws (4), and move the cutter holder
(5) to adjust so that the clearance between the cutter
and the needle bar (3) is 0.3 mm.
* Check that the needle bar (3) does not touch the
cutter when it moves sideways.
3980Q
HE-800B