Program Setting Method - Brother HE-800B Instruction Manual

5. USING THE SEWING MACHINE (OPERATION PANEL: BASIC OPERATION)

5-4. Program setting method

It is recommended that you register patterns that are sewn frequently as programs. After programs have been registered, you
can retrieve the desired sewing patterns simply by selecting a program number, which eliminates the need to set the pattern
each time.
• Normally up to 50 programs can be registered, and their contents can be changed at any time. The contents can be set by
changing the parameters for each item.
• At the time of shipment from the factory, temporary contents are set for programs P01 to P50. (The contents are the same
for all programs from P01 to P50.) Follow the method given below to change the contents of a program before using it.
1
Switch the mode to test feeding mode.
4785M
2
Select the program number from P01 to P50 (1) to select the program that you would like to change.
4787M
3
Switch to program mode.
4789M
33
Independent program
The program No. (1) changes in the order shown in the illustration
each time the key is pressed. (The
the opposite direction.)
NOTE:
Program mode is not available if a cycle program has been
selected.
The parameter number (2) that was last selected and the setting (3)
for that parameter will appear in the display.
* You can also start program mode by pressing a shortcut key. In
this case, the parameter number that corresponds to the shortcut
key will be selected. (Refer to the next page.)
HE-800B
4786M
Cycle program
(Refer to P. 52)
key changes the order in
4788M
4918M