Clearing Errors, Or Clearing Wrong Declaration Key Or Wrong Numeric Entries - TEC MA-516-100 SERIES Owner's Manual

Clearing Errors, or Clearing Wrong Declaration
Key or Wrong Numeric Entries
When in sale entries an error has occurred with an alarm buzzer (beeps for about 2 seconds only), a wrong Declaration
Key (such as [RTN MDSE], [TX/M], [GST/M], etc.) has been depressed, or a wrong numeric data has been entered;
depress the [C] key.
1) Error has occurred (the alarm
buzzer is generated and the
"ALM" lamp illuminates), and
the keyboard is locked.
2) Declaration Key has been de-
pressed.
RTN
Example)
MDSE
3) Numeric Keys are entered.
5 0 0
Example)
4) Declaration Key (s) + Numeric
Keys
RTN
Example)
7
MDSE
5) Numeric Keys + Non-motorized
Key (key that does not trigger
printing)
Example) 1 2
6) Combination of 2) to 5)
7) Combination of 6) + 1)
NOTE: When data is already entered and printed (through a Department Key, etc.), it cannot be cleared by the [C]
key any longer. In need of deleting such data, see the following:
Item Correction (Last Line Voiding)
Void (Designated Line Voiding)
All Void (Transaction Cancel)
Operations in " - " Mode
C
C
0
X
C
ITEM
CORR
ALL
VOID
VOID
- 39 -
C
The error condition is cleared (the
buzzer tone stops and the "ALM" lamp
is extinguished). Find the cause of the
error, and do the operation again. Re-
fer to "Possible Cause of Error" at-
tached where an error may occur in
each operation sequence on the fol-
lowing procedure.
The entered data are all cleared at once.
The entered data are all cleared at once,
and the error condition is cleared also.
Refer to 1) for finding the cause of error.
page 68
page 70
page 71
Chapter 20 (page 98)
EO1-11116
MA-516-100 SERIES
(Clear Key)