Brother DreamWeaver„ VQ3000 Operation Manual page 214

ERROR MESSAGES
Marks
OK to delete the setting?
Preventive maintenance is recommended.
Raise the buttonhole lever.
Sensor module error.
Set the clock.
The bobbin thread is almost empty.
The bobbin winder safety device has activated. Is the thread
tangled?
The ending point cannot be selected for this stitch.
The needle position cannot be changed for this stitch.
The needle will move. Keep your hands etc. away from the
needle area.
The pockets are full. Delete a pattern.
The safety device has been activated.Is the thread tangled? Is
the needle bent?
The shutoff support mode has been activated. Turn off the
machine.
The "Start/Stop" button does not operate with the foot
controller attached. Remove the foot controller.
The upper thread may not be threaded correctly. Thread the
upper thread from the beginning.
The USB media was changed. Do not change the USB media
while it is being read.
There is no needle plate cover. Attach a needle plate cover.
This file cannot be used.
This file exceeds the data capacity and cannot be used. Use a
suitable size file.
This function cannot be used while in the sensor mode.
This key cannot be used at this time.
A-30
Error Messages Cause/Solution
This message appears when
delete the settings for a utility stitch. To delete the selected
settings, press .
This message is displayed when the machine needs to be
maintained. (see page A-15)
This message is displayed when the buttonhole lever is down,
a stitch other than a buttonhole is selected, and the
"Start/Stop" button or the "Reverse Stitch" button is pushed.
This message appears when something is wrong with the
sensor unit of the machine. Consult your authorized dealer.
This message appears when the time/date is not set. Set
time/date. (see page B-20)
This message is displayed when the bobbin thread is running
out.
This message is displayed when the bobbin is being wound,
and the motor locks because the thread is tangled, etc.
This message appears when the function to specify the sewing
end point cannot be used with the current stitch. Select other
stitch. (see page B-69)
This message appears when the function to specify the needle
drop position cannot be used with the current stitch. Select
other stitch. (see page B-69)
This message appears when you touch the point closer than 2
cm from the needle drop point with the sensor pen in the
sensor function. (see page B-61)
This message is displayed when the memory is full and a
pattern must be deleted.
This message is displayed when the motor locks due to
tangled thread or for other reasons related to thread delivery.
This message appears when the machine is in the shutoff
support mode. Turn off the machine once to start the machine
again. (see page B-28)
This message is displayed when the "Start/Stop" button is
pushed to sew Utility stitches or Character/Decorative stitches
while the foot controller is connected.
This message is displayed when it seems that the upper
thread has not been threaded correctly.
This message is displayed when you attempt to select a
pattern after the USB media in which the pattern is saved has
been changed.
This message is displayed when the needle plate cover is not
attached.
This message appears if the file format is incompatible with
this machine. Check the list of compatible file formats. (see
page S-94)
This message is displayed when the file size exceeds the data
capacity of the machine.
Confirm the file size and format. (see page S-95)
This message appears when the selected function is not
available with the sensor function. (see page B-59)
This message is displayed when you press
the screen other than the Utility Stitch, or press
in the screen other than the Utility Stitch or
Character/Decorative Stitch.
or is pressed to
in