Configuring Lan Information For The Mp; Figure 5-7 The Lc Command Screen - HP rp8400 Series Installation Manual

System Installation

Configuring LAN Information for the MP

Configuring LAN Information for the MP
This section describes how to set and verify the server Management Processor (MP) LAN port information.
LAN information includes the MP network name, the MP IP address, the subnet mask, and gateway address.
This information is provided by the customer.
To set the MP LAN IP address:
1. At the MP Main Menu prompt (MP>), enter cm. From the MP Command Menu prompt (MP:CM>), enter
lc (for LAN configuration).
The screen displays the default values and asks if you want to modify them. It is a good idea to write
down the information, as it may be required for future troubleshooting.
NOTE If the Command Menu is not shown, enter q to return to the MP Main Menu, then enter cm
Enter lc and press the Return key. The following screen appears:
Figure 5-7 The lc Command Screen
MP:CM> LC
This command modifies the LAN parameters.
Current configuration of GSP customer LAN interface
MAC address : 00:30:6e:05:09:24
IP address
Hostname
Subnet mask : 255.255.255.0
Gateway
Status
AutoNegotiate : Enabled
Data Rate
Duplex
Error Count : 0
Last Error
Do you want to modify the configuration for the customer LAN? (Y/[N]) q
MP:CM>
The value in the "IP address" field has been set at the factory. Obtain the LAN IP address
NOTE
from the customer.
2. At the prompt, Do you want to modify the configuration for the customer LAN?, enter y.
The current IP address is shown; then the following prompt appears: Do you want to modify it? (Y/[N])
3. Enter y.
4. Enter the new IP address.
The customer shall provide this address for network interface 0.
70
: 15.99.83.215 (0x0f6353d7)
: quartz-s
(0xffffff00)
: 15.99.83.254 (0x0f6353fe)
: UP and RUNNING
: 100 Mb/s
: Half
: none
Chapter 5