Removing And Attaching The Mounting Plate - Epson EQUITY 3865X/20 PLUS User Manual

Removing and Attaching the Mounting Plate

If you are installing a new hard disk drive in your computer, you
need to attach a hard disk drive mounting plate to the drive.
This mounting plate is currently attached to the side of the
subassembly, as shown below.
Follow these steps to remove the mounting plate from your
computer:
1. Turn the subassembly so that the front panel area is facing
you. The vertical mounting area is located on the right side
of the subassembly.
2. Using a screwdriver, remove the screw securing the
mounting plate to the subassembly and set it aside. Then lift
up the mounting plate to remove it.
Installing and Removing Disk Dives
7-10
subassembly
mounting plate