Epson EQUITY 3865X/20 PLUS User Manual page 55

Enter. You
2.
Press
Drive 1:
Number of cylinders
Number of heads
Number of sectors 33
Precomp. cylinder
Landing zone
Total capacity (MB)
The submenu lists the settings you can change for each
drive: the number of cylinders, the number of read/write
heads, the number of sectors, the precompensation cylinder,
and the landing zone (the cylinder on which you park the
heads when moving the computer). It also displays the total
storage capacity in megabytes.
3. If you want to change the settings for drive 1 (which is
drive C on most computers), press
Drive 1:.
Enter
press
4. Enter
Press
None
Type
User defined
5. If you have disconnected the drive or if the drive does not
exist, highlight
settings become 0. Go to step 8.
If your hard disk matches one of the drive types listed in the
Hard Disk Drive Types table, go to step 6.
2-20 Running the Setup Program
see a menu such as the following:
Type 60
776
8
None
775
100.0
If you want to change the settings for drive 2,
and then + to highlight
again. You see this submenu:
60
None
and press
I
Drive 2: None
Number of cylinders 0
Number of heads
Number of sectors
Precomp. cylinder
Landing zone
Total capacity (MB) .0
Enter
to highlight
Drive
2 : .
Enter.
All the drive
I
0
0
0
0