Accessing Your Current Password - Epson Equity 320SX PLUS User Manual

Accessing Your Current Password

If you have forgotten your current password and cannot use
your computer, follow these steps:
1. Turn off the computer and follow the instructions under
"Changing the Jumper Settings" in Chapter 6 to disable
the password function by setting jumper J2 to position A.
Caution
Be sure to ground yourself on the back inside panel of
the computer before touching any of the interior
components. Always replace the cover on the
computer before you turn it on again.
2. Turn on the computer.
Password
3.
When the
appears, press
4. Highlight
menu.
Follow the instructions in Chapter 2 to either set a new
password or select
set a new password). Be sure to save your SETUP
information when you exit the program.
5. Turn off the computer and follow the instructions under
"Changing the Jumper Settings" in Chapter 6 to enable
the password function by setting jumper J2 to position B.
6. If you do not have a hard disk, insert the Startup diskette
in drive A. Turn on the computer.
If you set a new password, you see the
prompt. Enter the password to access your system. (See
"Using the Password" in Chapter 3.)
Troubleshooting
C-6
You
prompt.
Press <Del>to start SETUP
Del.
Run SETUP
and press
Not
do not see the
Enter. You see
Instal1ed (if you do not want to
Enter Password
Enter
prompt
the SETUP