Using A Password - Epson Equity 320SX PLUS User Manual

There are two ways to reset the computer:
press the
and then the computer should reload MS-DOS. If it
doesn't, try the next method.
works even when the computer does not respond to your
keyboard entries.
If resetting the computer does not correct the problem, you
probably need to turn it off and reboot it. Remove any
diskette(s) from the diskette drive(s). Turn off the computer
and wait five seconds. If you do not have a hard disk, insert
the Startup diskette in drive A. Then turn on the computer.

Using a Password

If you set a password when you ran the SETUP program, you
must enter it every time you turn on the computer or press
RESET
the
1. If you do not have a hard disk, insert your Startup
diskette in drive A.
2. Turn on the computer or press
completes its memory test, the screen displays the
following prompt:
Enter Password :
3. Type your password at the prompt. The screen does not
display the characters you
After you type the password correctly and press
see Press <Del> to start SETUP
the
press
Del,
MS-DOS command prompt.
key. The screen goes blank for a moment
Del
RESET
the button on the front panel. This method
button. Follow these steps to use your password:
the computer loads MS-DOS and displays the
Ctrl
RESET.
After the computer
type. Then press
prompt. If you do not
Using Your Computer
and Alt and
Enter.
Enter, you
3-5