Epson Equity 286 PLUS User Manual page 78

The message tells you the switches you should use to set the
speed to high or low. At the MS-DOS prompt, type the
ESPEED command again and include the appropriate switch,
such as the following:
ESPEED L
This command changes the processor speed to low.
To
see
the current CPU speed,
Enter. You
1 2 . 0 M H Z < - >
The processor speed you set remains in effect until you press the
RESET
button or turn off the computer, or until you change it
using the SETUP program, a keyboard command, or the
ESPEED
program again.
Entering the ESPEED command in a batch file
You may want to run the ESPEED program by including the
command in a batch file. For example, if you have a program
SAMPLE
called
could include the following commands in a batch file to start
SAMPLE
the
ESPEED L
SAMPLE
You could name the batch file
need to run the
in drive A. Then type
changes the speed to low and starts the SAMPLE program.
See your MS-DOS Reference Manual for instructions on
creating and using batch files.
Enhancing System Operations
4-6
see the following:
<+>
<Esc>: Exit
which requires a slower processor speed, you
program:
SAMPLE
program, insert the program diskette
SAMP
type ESPEED
: Speed Up
: Speed Down
SAMP.BAT.
Whenever you
Enter.
and press
only and press
The computer