Epson Equity 286 PLUS User Manual page 145

The following table lists the jumper settings for all the possible
hard disk drive configurations.
X = jumper installed
- = no jumper installed
To move a jumper from one position to the other, use your
fingers, needle-nose pliers, or tweezers to pull it off its pins and
gently move it to the other position. Be careful not to drop the
jumper or damage the pins as you install it.
If you are going
should be set in positions
these settings. Then see "Installing a Hard Disk in the Vertical
Position" on page B-7 for instructions on installing your first
hard disk drive.
If you'll be using two hard disk drives, you have a total of four
jumpers for eight jumper positions. Two jumpers are included
with each drive. Install three of the jumpers on the master drive
C/D, DSP,
in positions
the slave drive in position
If you are installing both of your hard disk drives at one time,
you should install the drive in the horizontal drive bay first. See
"Installing or Removing a Disk Drive in the Horizontal
Position" on page B-27 for instructions.
B-6
Installing
and
use only one hard disk drive, the jumpers
to
C/D
and
ACT.
and
ACT.
Removing Disk Drives
ACT.
If not, change them to
Install the fourth jumper on