Epson Equity 286 PLUS User Manual page 34

3. Turn on the monitor, printer, and any other peripheral
devices connected to the computer.
4. To turn on the computer, press the power button located on
the right side of the front panel, as shown below.
The power indicator next to the button lights up. After a few
seconds, the computer counts the amount of memory in your
computer, and then performs a diagnostic self test. This is a
series of checks the computer completes each time you turn it on
to make sure everything is working correctly.
If necessary, use the controls on your monitor to adjust the
brightness and contrast until characters on the screen are clear
and at a comfortable level of intensity. If your monitor has
horizontal and vertical hold controls, you may need to use them
to stabilize the display.
Note
If you or your dealer have made a major change to your
system, such as adding a disk drive, you may need to wait
several minutes for your computer to complete power-on
diagnostics the first time you turn it on.
power button
Setting Up Your System
1-17