Epson Equity 286 PLUS User Manual page 179

Position the power supply cable connector so that the
notched comers on the connector line up with the notched
comers of the power supply socket on your drive.
notched corners
Make sure the holes fit over all the pins and then push the
connector onto the pins.
Caution
If you do not correctly align the holes with the pins, you
could severely damage your drive when you push in the
connector.
If you do not need to reinstall a vertically mounted hard disk
drive, see "Replacing the Subassembly" on page B-46.
If
you just
vertically mounted hard disk drive, perform step 8 again to
connect the power supply cable to the drive you just
installed in the horizontal drive bay. Then see "Replacing
the Drive on the Subassembly" on the next page for
instructions on reinstalling the vertically mounted drive.
B-40 Installing and Removing Disk Drives
connected the power supply cable to your
notched corners