Storing A Picture Profile On An Sxs Memory Card - Sony PMW-F3K Operating Instructions Manual

Storing a Picture Profile on an SxS
Memory Card
A picture profile can be sent to and stored on an
SxS memory card as a file (filename:
PPDATA.SUF).
Only one picture profile can be stored on the same
memory card. The stored picture profile can be
immediately reproduced by reading from the
memory card.
Storing a Picture Profile
1
Insert a recordable SxS memory card
into a slot.
Confirm that the corresponding access lamp
is lit in green.
2
Select the picture profile to be stored.
The selected picture profile number is
displayed at the bottom of the screen.
See "Selecting a Picture Profile using the
P.PROFILE menu" on page 72.
3
Select "SET" of the P. PROFILE menu.
4
Select "Store" of "PP Data."
P.PROFILE
PP1: STANDARD
SEL
Black
SET
Black Gamma
Low Key SAT
Copy
PP Data
Reset
The message "PP Data Store Execute/
Cancel" is displayed at the bottom of the
screen.
5
Select "Execute."
Writing of the selected picture profile to the
memory card begins.
When writing ends, the completion message is
displayed for three seconds, and the original
screen display is restored.
: 0
: 0
: 0
B
B
S t o re
Reca l l
Note
After you start writing, do not remove the SxS
memory card until the completion message is
displayed.
Loading a Picture Profile
1
Insert the SxS memory card that
contains the picture profile to be loaded
into a slot.
Confirm that the corresponding access lamp
is lit in green.
2
Select the picture profile name for
which the picture profile is to be loaded
from the memory card.
The selected picture profile number is
displayed at the bottom of the screen.
See "Selecting a Picture Profile using the
P.PROFILE menu" on page 72.
3
Select "SET" of the P.PROFILE menu.
4
Select "Recall" of "PP Data."
The message "PP Data Recall Execute/
Cancel" is displayed at the bottom of the
screen.
5
Select "Execute."
Loading of the picture profile from the
memory card begins.
When overwriting to the picture profile you
specified in step 2 ends, the completion message
is displayed for three seconds, and the loaded
settings are immediately reflected.
Note
After you start loading, do not remove the SxS
memory card until the completion message is
displayed.
Picture Profiles 73