Attaching A Lens - Sony PMW-F3K Operating Instructions Manual

Solid-state memory camcorder
Hide thumbs Also See for PMW-F3K:
Table of Contents

Advertisement

Attaching a Lens

Usable lenses
The following lenses are supplied with the PMW-
F3K.
• SCL-P35T20 (focal length: 35mm)
• SCL-P50T20 (focal length: 50mm)
• SCL-P85T20 (focal length: 85mm)
In addition to equivalents of the lenses supplied
with the PMW-F3K, various PL-mount lenses
can be used with the PMW-F3K/F3L.
The following optional lenses can also be used
with the camcorder.
• SCL-Z18X140 FZ Power Zoom Lens 14.0X
(usable with a camcorder with software version
1.20 or higher)
• SCL-P11X15 PL Lens Wide Angle Zoom X1.5
(usable with a camcorder with software version
1.30 or higher)
For other lenses usable with the PMW-F3K/F3L, ask
a Sony service representative.
For information on handling optional lenses, refer to
the operation guide of the lenses.
Caution
Do not leave the camcorder with the lens facing
the sun. Direct sunlight can enter through the lens,
be focused in the camcorder, and cause fire.
Attaching a Lens
Notes
• Turn off the camcorder before attaching/
removing the lens.
• The lens is a precision component. Do not place
it with the mount side down directly touching a
surface. Be sure to attach the supplied cap.
• The camera interface of the camcorder is set to
"Type C" for the lenses supplied with the
PMW-F3K and those having a Cooke
connector. When attaching a lens with an ARRI
connector (usable in the future), set the interface
to "Type A" with "Lens IF" (page 114) of the
CAMERA SET menu. Or set it to "Off" for
other lenses.
If the interface setting is not correct, a warning
message will be displayed when you turn on the
camcorder.
For details on menu operations, see "Basic Menu
Operations" on page 108.
Attaching a PL-mount lens
1
Turn the lens mount frame
counterclockwise and remove the
mount cap from the lens mount.
2
Align the recess of the lens with the
alignment pin at the upper part of the
lens mount of the camcorder and set the
lens in place.
3
While holding the lens, turn the lens
mount frame clockwise to secure the
lens.
1)
When using an ARRI
LDS lens or a Cooke /i
lens
Align the contacts of the lens with the
corresponding hot shoe of the camcorder.
3
2
Attaching a Lens
29

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pmwf3l/rgb

Table of Contents