Reconnecting The Cables To The Diskette Drive - Epson User Manual

Reconnecting the Cables to the Diskette Drive

Refer to the illustration below while you follow these steps:
red wire
Locate the connector on the diskette drive ribbon cable.
1.
Identify pin 1 on the drive and align the connector so that
2.
the red wire is at pin 1. Push in the connector.
Locate the power supply cable with the small connector.
3.
Position the power supply cable connector so that the holes
4.
fit over all the pins and the red wire aligns with pin 1 on
the drive's connector. Then push in the connector.
If you have finished installing or removing drives, replace
5.
the computer's cover, as described under "Replacing the
Cover" in Chapter 4. Then see "Using the Fixed Disk Setup
Option" in Chapter 2 for instructions on defining your new
drive configuration.
Installing and Removing Slimline Drives
5-12
red wire