Epson User Manual page 47

Green PC options (continued)
Option
System Suspend
Timer
VGA with Power
Down feature
Non_SMI CPU
support
IDE Hard Disk
Standby Timer **
System enters
Doze/Standby
modes by VGA
access event
System wakeup
from Suspend
modes by (list of
13 sources of SMI
access)
L
* Default setting
** Some hard disk drives do not support a low-power standby mode. Also, the
delay caused by the hard disk drive returning to active mode may cause
errors in some applications. If you have problems, you may want to disable
the Hard Disk Standby Timer option (Disabled is the default setting).
Settings
2 minutes*
4 minutes
8 minutes
16 minutes
32 minutes
64 minutes
128 minutes
256 minutes
512 minutes
Disabled
VESA DPMS
Standard
None *
Generate IRQlO *
Generate lRQl5
Disabled
1 to 15 minutes
15 minutes *
On
Off *
On*
Off
Running SETUP and Installing Drivers
Description
Sets the time period of system
inactivity (following any Doze
and Standby periods that are
set) after which the system
enters Suspend mode or allows
you to disable entry into
Suspend mode
Selects the method the VGA
chip uses to enter Doze mode
Allows the ISA bus bridge
controller to replace the System
Management Interrupt (SMI)
request when a non-system
management mode CPU is
used, for instance, an Intel® DX,
SX, or DX2 processor
Sets the time period of hard disk
drive inactivity after which the
hard disk enters Standby mode
or allows you to disable the
hard disk standby timer
Enables or disables checking of
video activity to determine
whether the system enters a
power-saving mode
Selects the SMI access events
from which the system exits
Suspend modes: you can set
each type of event to On or Off
2 - 1 7