Removing A Drive From An External Bay - Epson User Manual

11. If you have finished installing or removing drives, replace
the computer's cover, as described under "Replacing the
Cover" in Chapter 4. Then see "Using the Fixed Disk Setup
0ption" in Chapter 2 for instructions on defining your new
drive configuration.

Removing a Drive from an External Bay

You may need to remove a drive for service or replacement.
Caution
Before you remove a hard disk drive, make sure you have
backup copies of all your files and programs. You can use
backup software or the backup utility in your operating
system. Refer to the online help files or software
documentation for instructions.
If your system included a Recovery CD-ROM, it contains an
image of your hard drive as it was configured at the factory.
You can use this CD-ROM to restore the original files that
came on the hard drive; you cannot restore any data files
you have created.
To remove a drive from an external drive bay, follow these
steps:
1. Remove the drive mounting bracket, following the
instructions under "Removing the Drive Mounting
Bracket." (You can remove the bracket and drives without
disconnecting the drive cables.)
2. Disconnect all cables from the drive you are removing.
5-22 Installing and Removing Slimline Drives