Option Card Problems - Epson User Manual

If you connected a scanner to the parallel port, make sure the
port is set for bidirectional operation (ECP mode) ; see
"Configuring integrated peripherals" in Chapter 2 for more
information. If you use ECP mode, check your parallel device
software documentation for the correct DMA channel (DRQ)
setting; then set jumpers JPS and JP18 to match the setting, if
necessary. See "Changing the Jumper Settings" in Chapter 4 for
more information.
The printer prints garbled information.
Check the printer manual for the printer's correct DIP switch or
control panel settings. Also, make sure you have the proper
drivers installed for your printer and make sure you've
selected the correct printer within your software application.

Option Card Problems

A newly installed option card is not working correctly.
Make sure the option card is installed correctly and is
well-seated in its slot. Run SETUP to update your configuration
after you install the card. If you are using Windows 95, turn on
the Reset Configuration
SETUP program" and "Using the Advanced System Setup
0ptions" in Chapter 2 for instructions. Perform setup
procedures for any software you are using with the card.
See the documentation that came with the option card to set
any necessary DIP switches or jumpers on the card. The
computer may also have some jumpers that must be set for the
option card to work properly. See "Changing the Jumper
Settings" in Chapter 4 for more information.
Make sure you install option cards that do not exceed the
system's power supply limits; see "Option Slot Power Limits"
in Appendix A for more information.
Data option. See "Starting the
Troubleshooting 7-15