Operation; Power Bar; Low Capacity Warning; Battery Protection - Craftsman 320.28102 Operator's Manual

POWER BAR
[] This Lithium-Ion battery pack is equipped with a POWER BAR which is used to display the
battery pack's remaining run time_ Press the POWER BAR button to display the LED lights. The
LED lights will stay lit for approximately 4 seconds.
NOTE: The POWER BAR can be used when the battery is attached or removed from tool,J
Fig, 2
000@
0000
0000
0000
ooo÷
80-100%
Charge
60-79%
Charge
40-59%
Charge
20-39%
Charge
Under 10%
Charge
Completely
discharged
LOW CAPACITY WARNING
[] If one LED on the POWER BAR begins to flash, the battery pack's charge is under 10%
capacity and should be recharged_
[] Unlike other battery pack types, Lithium-ion battery packs deliver fade-free power for their
entire run time° The tool will not experience a slow, gradual toss of power as you work. To
signal that the battery pack is at the end of its run time and needs to be charged, power to the
toot will drop quickly.. The POWER BAR will begin to display four flashing LED lights when it is
comptetely discharged_ When this happens, remove the tool from the workpiece and charge
the battery pack as needed°
NOTE: The POWER BAR may also display four flashing LED lights due to an overload |
1
or high temperature situation (see SmartChip
TM
Battery protection).
/
SmartChip
TM
BATTERY PROTECTION
SmartChip
TM
intuitive circuitry protects the battery pack from extreme temperature, over-discharge
and over-charge. To protect the battery from damage and prolong its life, the battery pack's
SmartChip
TM
circuitry wilt turn off the battery pack if it becomes overloaded or if the temperature
becomes too high during use_ This may happen in extremely high torque, binding and staliing
situations° This intelligent system will shutdown your battery pack if its operating temperature
exceeds 176°F (80°C) and wilt begin normal operation when it returns to 32°F (0°C) - 122°F (50°C).
[] The POWER BAR wilt display four flashing LED lights if the SmartChip
TM
circuitry detects a
momentary overload° You can conveniently reset the battery pack by pressing the POWER
BAR button. Press the POWER BAR button again to display the remaining charge.
NOTE: If the POWER BAR continues to flash four LED lights after reset, place the I
I
battery pack on the charger to evaluate the battery condition (see Fig. 4).
I
16