Using The Laser Track Laser Guide; Using The Led Worklight - Craftsman 320.28102 Operator's Manual

_WAR_IIING:
LASER LIGHT. LASER RADIATION° Avoid Direct Eye Exposure,
DO NOT stare into beam. Only turn laser beam on when the saw is on the workpiece.
The laser is factory installed and aligned. Class Ilia laser.
I NOTE: Make a trial cut on a piece of scrap material to ensure the laser is aligned properly. 1
I
USING THE LASER TRAC
TM
LASER GUIDE
(Fig,, I4-!5)
To operate the laser guide:
[] Remove battery pack from saw
[] Mark the line to be cut on the workpieceo
Adjust the depth and angle of the cut as
neede&
[] Install the battery pack.,
[] Slide the Laser!LED switch back to turn
laser on,
[] Start the saw,
Fig, t4 Laser/LED
switch
NOTE: Do not touch the blade to the
workpiece until the saw has reached
maximum speed.
[] Align laser beam with fine-of-cut and slowly
push the saw forward into the workpiece
[] Once the cut is complete, release the
trigger switch and allow the saw to come to
a complete stop
[] Always turn laser beam off when you have
finished cutting,
USING THE LED WORKLIGHT (Fig. I4 & '16)
The saw is equipped with a fixed-position
worklight for better visibility when cutting,,
To operate the LED worklight:
[] Slide the Laser/LED switch forward to turn
worklight on,
NOTE: The laser guide or worklight will
automatically shut off approximately
four to seven minutes after the switch
trigger is released,
_WARNIING; The worklight aids
in illuminating the cut-line. It is NOT
a substitute for adequate work area
lighting. Failure to obey this warning
could cause serious personal injury.
F_g. t¢
Field of illumination
3 4
23