Table of Contents
Advertisement
REGISTER / DELETE SOUND DATA
You can take the same procedure to change both shutter sound and
photo-preparation sound.
Turn the DIAL SWITCH to SET UP MODE and then
turn the POWER ON.
The SETUP menu will appear on the LCD monitor.
1.
Use the ud buttons and select a Shutter Sound, Focus Lock Sound or
Self Timer Sound.
2.
Use the l r buttons and select the item to change.
You can select the item in the order as beep sound ➝ sound1 ➝ sound2.
You can register sound1 and sound2.
3.
Press the
FLASH button.
The sound data registered in the camera body is displayed.
4.
Use the r button and display the sound data in the memory card.
The next steps are all continued from step
Note:
If the sound data had the same name as one in the camera body, a message
on overwriting confirmation will be displayed. Press the
to confirm the new sound with replacing the old sound of the same number.
REGISTER SOUND DATA
5.
Use the ud buttons and select the sound data to register.
You can play the sound by pressing the
6.
Press the
FLASH button.
A copy confirmation request message will appear.
If the camera is low on memory space, the new sound cannot be copied.
Delete the old sound first, then copy the new one.
7.
Press the
MACRO button.
The new sound is copied to the camera. To cancel this operation, press
the
FLASH button.
48
ADDITIONAL SETTINGS
5
.
FLASH button
REVIEW button.
DELETE SOUND DATA
If (in step 6 above) there was not enough memory space for new sounds,
delete the old sounds as follows;
5.
Use the ud buttons and select the sound data to delete.
You can play the sound by pressing the
6.
Press the
MACRO button.
A delete confirmation request appears.
7.
Press the
FLASH button.
The sound data is deleted.
AUTO POWER SAVE
When the camera is turned on but inactive for a period of time, the camera
automatically shuts down to save battery power.
1.
When there is no activity for over
3 minutes, the camera will enter
sleep mode.
While in Sleep mode, the green
light will blink. The LCD monitor
will turn off and the CPU will also
be in sleep mode.
Note:
To cancel Sleep mode, press the
SHUTTER button, or any other
button on the back of the camera. You
can also simply turn the DIAL
SWITCH.
2.
When the camera is left in Sleep mode for over 10 minutes, it will shut
down automatically.
The lens will retract and the lens cover will close.
REVIEW button.
Indicator light (green)
LCD monitor
Advertisement
Table of Contents
