Table of Contents
Advertisement
Other Potential Problems
Topic
DOS ASPI
CD-ROM drives
under DOS
Physical Drive Errors
Virtual Sizing
BSD Unix
Multiple LUNs
Power Requirements
Chapter 7 Troubleshooting
ADACASPI.SYS, the DOS ASPI manager, uses 6 KB of
system memory once it is loaded.
At this time, copied CDs are not accessible from DOS even
after loading ADACASPI.SYS and ADACDROM.SYS.
To display the ADAC Configuration Manager Media Error
and Other Error options, press <F2> after selecting a
physical drive under the Physical Drive menu, selected
from the Objects menu. A Media Error is an error that
occurred while actually transferring data. An Other Error is
an error that occurs at the hardware level because of a
device failure, poor cabling, bad termination, signal loss,
etc.
The Virtual Sizing option enables RAID expansion. Virtual
Sizing must be enabled to increase the size of a logical
drive or add a physical drive to an existing logical drive.
Run ADAC Configuration Manager by pressing <Ctrl>
<M> to enable Virtual Sizing. Select the Objects menu,
then select the Logical Drive menu. Select View/Update
Parameters. Set Virtual Sizing to Enabled.
We do not provide a driver for BSDI Unix. ADAC Ultra2
S466 does not support BSDI Unix.
ADAC Ultra2 S466 supports one LUN per each target ID.
No multiple LUN devices are supported.
The maximum ADAC Ultra2 S466 power requirements are
15 watts at 5V and 3 Amps.
Information
79
Advertisement
Table of Contents
