Table of Contents
Advertisement
Installation Steps
Step
1
Unpack the ADAC Ultra2 S466 controller
and inspect for damage. Make sure all
items are in the package.
2
Turn the computer off and remove the
cover.
3
Make sure the motherboard jumper settings
are correct.
4
Install cache memory on the ADAC Ultra2
S466 card.
5
Check the jumper settings on the ADAC
Ultra2 S466 controller.
6
Set SCSI termination.
7
Install the ADAC Ultra2 S466 card.
8
Connect the SCSI cables to SCSI devices.
9
Set the target IDs for the SCSI devices.
10 Replace the computer cover and turn the
power on.
11 Run ADAC BIOS Setup.
12 Install software drivers for the desired
operating systems.
54
ADAC Ultra2 S466 Hardware Guide
ADAC Ultra2 S466 provides extensive customization
options. If you need only basic ADAC Ultra2 S466
features and your computer does not use other adapter
cards with resource settings that may conflict with ADAC
Ultra2 S466 settings, even custom installation can be quick
and easy.
Action
Each step is described in detail below.
Additional Information
If damaged, call your
Gateway OEM support
representative.
4 MB minimum cache
memory is required.
See page 57 for the ADAC
Ultra2 S466 jumper
settings.
Be sure the SCSI devices
are powered up before or at
the same time as the host
computer.
Optional.
Cont'd
Advertisement
Table of Contents
