Hardware Requirements; Configuration Features - Gateway ADAC Ultra2 S466 Hardware Manual

Hardware Requirements

Configuration Features

Specification
RAID Levels
SCSI Channels
Maximum number of drives per channel
Array interface to host
Drive interface
Upgradable cache size
Cache Function
Multiple logical drives/arrays per
controller
Maximum number of ADAC Ultra2 S466
controller per system
Online capacity expansion
Dedicated and pool hot spare
Flashable firmware
Hot swap devices supported
Non-disk devices supported
Mixed capacity hard disk drives
Number of 16-bit internal connectors
Number of 16-bit external connectors
Support for hard disk drives with
capacities of more than 8 GB.
Clustering support (Failover control)
Online RAID level migration
RAID remapping
No reboot necessary after expansion
More than 200 Qtags per physical drive
Hardware clustering support on the board
User-specified rebuild rate
30 ADAC Ultra2 S466 Hardware Guide
ADAC Ultra2 S466 can be installed in an IBM AT®-
compatible or EISA computer with a motherboard that has
5 volt PCI expansion slots. The computer must support
PCI version 2.0 or later. The computer should have an Intel
Pentium, Pentium Pro, or more powerful CPU, a floppy
drive, a color monitor and VGA adapter card, and a
keyboard. A mouse is recommended.
Feature
0, 1, 3, 5, 10, 30, and 50.
15
PCI 2.1
Fast and Wide Ultra SE and LVD
4 MB, 8 MB, 16 MB, 32 MB, 64 MB,
or 128 MB
Write-through, write-back, ARA,
NRA, RA
Up to 8 logical drives per controller
12
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
Yes
Yes
Yes
Yes
Yes
Yes
1
1
1