Table of Contents
Advertisement
Step 11 Run ADAC BIOS Setup
Step 12 Install Operating System Driver
ASPI Driver
Drivers
.SYS
ADACASPI
Parameters
Parameter
/h
INT 13h support is not provided.
/v
Verbose mode. All message are displayed on the screen.
/a
Physical drive ccess mode. Direct access to physical drives is
permitted.
/q
Quiet mode. All message except error message are suppressed.
70
ADAC Ultra2 S466 Hardware Guide
Press <Ctrl> <M> to run the ADAC BIOS Setup utility.
See the ADAC Ultra2 S466 Configuration Software Guide
for information about running BIOS Setup.
The ADAC Ultra2 S466 ASPI driver can be used in the
DOS and Windows 95 environments. The DOS ASPI
driver supports:
up to six non-disk SCSI devices (each SCSI device
must use a unique SCSI ID regardless of the SCSI
channel it resides on. SCSI IDs 1 through 6 are valid,
up to 12 ADAC Ultra2 S466 adapters, and
virtual DMA services (VDS) for up to eight logical
drives.
CorelSCSI, Novaback, and PC Tools are not provided with
ADAC Ultra2 S466.
Devices Supported
CD-ROM, tape,
optical drives, etc.
Copy ADACASPI.SYS to your hard disk drive. Add the
following line to CONFIG.SYS:
device=<path>\ADACASPI.SYS /v
The ADACASPI.SYS parameters are:
Application Software
CorelSCSI, Novaback, PC
Tools.
Description
Features
VDS
Cont'd
Advertisement
Table of Contents
