Table of Contents
Advertisement
ADAC Ultra2 S466 Specifications
Parameter
Card Size
Processor
Bus Type
PCI Controller
Bus Data Transfer Rate
BIOS
Cache Configuration
Firmware
Nonvolatile RAM
Operating Voltage
SCSI Controller
SCSI Data Transfer
Rate
SCSI Bus
SCSI Termination
Termination Disable
Devices per SCSI
Channel
SCSI Device Types
Supported
RAID Levels Supported
SCSI Connectors
Serial Port
34
ADAC Ultra2 S466 Hardware Guide
7.375" x 4.2" (half length PCI)
Intel i960RP™ 32-bit RISC processor @ 33 MHz
PCI 2.1
Intel i960RP
Up to 132 MB/s
AMIBIOS ADAC Ultra2 S466 BIOS
4, 8, 16, 32, 64, or 128 MB through a 60 ns × 36
Fast Page Mode or EDO 72-pin SIMM.
1 MB × 8 flash ROM
32 KB × 8 for storing RAID configuration
5.00 V ± 0.25 V
One SCSI controller for Ultra and Wide support.
Up to 80 MB/s
LVD or single-ended
Active
Automatic through cable and device detection
Up to 15 wide or seven non-wide SCSI devices. Up
to 6 non-disk SCSI drives per ADAC Ultra2 S466
controller.
Synchronous or Asynchronous. Disk and non-disk.
0, 1, 3, 5,10, 30, and 50
One 68-pin internal high-density connector for 16-
bit SCSI devices. One ultra-high density 68-pin
external connector for Ultra and Wide SCSI.
9-pin RS232C-compatible berg
Specification
Advertisement
Table of Contents
