Running The Echo Test - 3Com Fast EtherLink XL PCI 10/100BASE-TX User Manual

4-6 C
HAPTER

Running the Echo Test

The echo test tests the 3C905B-TX NIC's ability to transmit
and receive data while on the network.
You need two PCs with 3Com NICs installed to run an echo
test: one PC to send data and one PC to receive data.
CAUTION: Running the echo test while connected to an
active network can cause intermittent failures. To avoid
this, connect to an inactive network on which only the PC
being tested is operating.
To run the echo test, follow these steps:
1 Make sure that the 3C905B-TX NIC is installed in the
sending PC and connected to the network
and that the network driver is installed
2 Install a 3C905B-TX NIC in another PC (the echo server),
connect it to the network, and install the network
driver.
The echo server PC is the responding PC.
3 On both PCs:
a Click the Windows Start menu.
b Select Programs.
c Select 3Com NIC Utilities.
d Select 3Com NIC Diagnostics.
e Click the Diagnostics tab to display the Diagnostics
4 Click Respond on the Diagnostics screen
of the responding PC.
The Echo Test Responder screen appears on the
responding PC.
5 Click Start on the Echo Test Responder screen.
6 On the Diagnostics screen
PC, click Send.
7 On the Diagnostics screen
PC, click Start.
The statistics for the test appear in the Statistic section of
the window.
4: T
ROUBLESHOOTING
screen, shown in Figure 4-3.
(Figure
(Figure
(Chapter
(Chapter
(Figure
4-3) of the sending
4-3) of the sending
2)
3).
4-3)