Read And Understand - Craftsman 320.29004 Operator's Manual

20 volt lithium-ion cordless 1/2" hammer drill/driver
Table of Contents

Advertisement

_WARNING:
READ AND UNDERSTAND
ALL INSTRUCTIONS.
Failure to follow all
instructions listed below may result in electric shock, fire and/or serious personal injury.
Before using battery charger,
read all instructions and cautionary
markings in this manual,
on battery charger, battery and product using battery to prevent misuse of the products and
possible injury or damage.
_kC.&UI"ION:
To reduce the risk of electric shock or damage to the charger and battery,
charge only lithium-ion
rechargeable
batteries
as specifically
designated
on your charger.
Other types of batteries
may burst, causing
personal
injury or damage.
Do not use charger, outdoors
or expose to wet or damp conditions.
Water entering
charger, will increase the risk of electric shock.
Use of an attachment
not recommended
or sold by the battery charger, manufacturer
may result in a risk of fire, electric shock or injury to persons.
Following this rule will
reduce the risk of electric shock, fire or serious personal injury.
Do not abuse cord or charger,
Never use the cord to carry the charger, Do not pull the
charger cord rather than the plug when disconnecting
from receptacle,
Damage to the
cord or charger could occur and create an electric shock hazard, Replace damaged cords
immediately,
Make sure cord is located
so that it will not be stepped on, tripped
over, come in
contact with sharp edges or moving parts or otherwise subjected
to damage or stress.
This will reduce the risk of accidental
falls, which could cause injury and damage to the cord,
which could result in electric shock.
Keep cord and charger from heat to prevent damage to housing or internal parts.
Do not let gasoline,
oils, petroleum-based
products, etc. come in contact with plastic
parts. They contain chemicals
that can damage, weaken or destroy plastic.
• An extension
cord should not be used unless absolutely
necessary.
Use of improper
extension
cord could result in a risk of fire and electric shock. If an extension cord
must be used, make sure:
1. That pins on plug of extension cord are the same number, size and shape as hose of plug on
charger.
2. That extension cord is properly wired and in good electrical condition;
and
3. That wire size is large enough for AC ampere rating of charger as specified below:
Cord Length (Feet)
25'
50'
100'
Cord Size (AWG)
16
16
16
NOTE: AWG = American
Wire Gauge
Do not operate charger
with a damaged
cord or plug, which could cause shorting and
electric shock. If damaged, have the charger repaired or replaced by an authorized
service
technician
at Sears Service Center.
Do not operate charger if it has received a sharp blow, been dropped or otherwise
damaged
in any way. Take it to an authorized service technician
at Sears Service Center for
an electrical check to determine
if the charger is in good working order.
Do not disassemble
charger. Take it to an authorized service technician
at Sears Service
Center when service or repair is required,
Incorrect reassembly
may result in a risk of electric
shock or fire,
Unplug charger from outlet before attempting
any maintenance
or cleaning to reduce
the risk of electric
shock.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents