Fujitsu SOFTUNE User Manual page 119

Notes:
• The conditions which allow you to use the commands in Table 2.3-2 are limited to the following
cases when a user program is executed.
- [Debug] - [Run] - [Go] menu
- [Go] button on the debug toolbar
The commands in Table 2.3-2 cannot be used when the GO command is entered in the command
window.
• An error message appears if you enter a command that cannot be used during the execution of a
user program.
"E4404S Command error (MCU is busy)."
CHAPTER2 Dependence Functions
109