Interrupt Simulation - Fujitsu SOFTUNE User Manual

2.1.4

Interrupt Simulation

This section describes interrupt simulation executed.
■ Interrupt Simulation
This simulates the MCU operation for an interrupt request. The following types can be used to allow an
interrupt to occur.
• When the instruction is executed as many cycles as the specified cycle count while executing a program
(executing execution commands), generate an interrupt corresponding to the specified interrupt number
to reset the interrupt generating condition.
• Whenever the instruction executing cycle count exceeds the specified cycle, an interrupt continues to be
generated.
The type of interrupt can be set using either the [Setup] - [Debug Environment] - [Interrupt] menu, or the
SET INTERRUPT command in the Command window. If an interrupt is masked by an interrupt-enabled
flag when the interrupt generating condition is met, the interrupt is generated after resetting the mask.
When an interrupt is generated while executing a program, an interrupt cause number is displayed on the
Status Bar.
Furthermore, the simulator supports the MCU operation for interrupt requests for the following exception
processing.
• Executing undefined instruction
CHAPTER2 Dependence Functions
39