Reset Simulation - Fujitsu SOFTUNE User Manual

CHAPTER2 Dependence Functions
2.1.5

Reset Simulation

This section describes the reset simulation executed.
■ Reset Simulation
The simulator simulates the operation when a reset signal is input to the MCU using the [Debug]-[Reset
MCU] menu or RESET command, and initializes the registers.
The function for performing reset processing by operation of MCU instructions (writing to RST bit in
standby control register) is also supported.
The register with the RST bit is different according to the FR/FR80 as follows.
FR
FR80
40
:Standby mode Control Register
:Reset Control Register