Installing An Accessible Drive - Fujitsu Siemens Computers CELSIUS M Operating Manual

Installing an accessible drive

► Open the casing (see "Opening the casing").
► If a slide-in module is fitted, remove this first. To do this, proceed in the same way as when
removing an accessible drive (see "Removing an accessible drive").
Do not dispose of the empty slide-in module. For cooling, protection against fire, and in
!
order to comply with EMC regulations, you must refit the empty slide-in module if you
remove the drive again later.
► Take the new drive out of its packaging.
► Make the desired settings on the new drive (if necessary, to the settings of drives already
installed as well (Master/Slave)).
2
► Slide the accessible drive into the casing as far as the stop (1).
► Plug the data and the power supply connectors into the drive. Make sure the polarity is correct.
► Fasten the drive into place with the screws (2).
► Close the casing (see "Closing the casing").
It may be necessary to modify the entry for the drive in the BIOS Setup .
i
A26361-K990-Z120-1-7619, Edition 6
2
System upgrades
1
63