Setting Up The Device - Fujitsu Siemens Computers CELSIUS M Operating Manual

Preparing for use

Setting up the device

When installing your device, give consideration to the safety notes in the "Safety" manual.
!
The device should only be set up in the intended orientation, i.e. in a vertical position.
We recommend that you place your device on a surface with good anti-slip qualities. In
view of the multitude of different finishes and varnishes used on furniture, it is possible that
the feet of the device will mark the surface they stand on.
Do not expose the device to extreme environmental conditions (see "Technical data").
Protect the device from dust, humidity, and heat.
Make sure that the device is adequately ventilated. In order to avoid overheating, do not
cover the ventilation area of the monitor or the device.
Depending on the location of your device, bothersome vibrations and noises may occur.
To prevent this, a distance of at least 3 mm should be maintained from other devices on
casing sides without ventilation surfaces. In addition, we recommend placing the device on
support feet, as these buffer vibrations.
Screwing on the base foot (CELSIUS V, CELSIUS R6xx)
To ensure a secure stance, the base foot must be screwed on prior to start-up.
► Lift the device slightly at the rear.
► Push the base foot under the device in the direction of the arrow (1).
Make sure that the screw holes for the screws are aligned.
► Screw on the base foot with the knurled screws (2).
8
2
2
1
A26361-K990-Z120-1-7619, Edition 6