Fujitsu PCI Gigabit Ethernet User Manual page 24

Parameter
LinkSpeed_A (*1)
DuplexCapabilities_A (*1)
FlowControl_A (*2)
fjgi_mtu
AutoNegotiation_A
Role_A (*4)
ReceiveTicks
TransmitTicks
ReceiveMaxBD
Value
Auto (default)
1000
100
10
Both (default)
Half
Full
Auto (default)
Rem
LocSend
None
1500 (default) to 9000 (*3)
On (default)
Off
Auto (default)
Master
Slave
0 to 1000 (*3)
(default: 77)
0 to 1000 (*3)
(default: 500)
1 to 500 (*3)
(default: 10)
- 18 -
Description
Any connection speed of 1000, 100, or 10
Mbps is set based on negotiation with the
remote device. (This is effective only
when AutoNegotiation_A=On.)
Connect at 1000Mbps.
Connect at 100Mbps.
Connect at 10Mbps.
Both Full-Duplex and Half-Duplex are
enabled. (This is effective only when
AutoNegotiation_A=On.)
Half-Duplex operation is enabled.
Full-Duplex operation is enabled.
Flow control is performed according to
the setup of the remote device.
Only flow control from the remote device
is allowed. Flow control from the local
device is not allowed.
Only flow control from the local device is
allowed. Flow control from the remote
device is not allowed.
Flow control is disabled.
MTU (byte) is specified.
Auto-Negotiation is enabled. The
interface will not be able to communicate
with remote device operating in fixed
mode (Auto-Negotiation disabled).
When SE0X7GD1X, SE0X7GQ1X,
SE0X7GQ2X is used in 1000Mbps mode,
use this setting.
Auto-Negotiation is disabled. (Forced
mode)
Master or Slave is set based on
negotiation with the remote device. (This
is effective only when
AutoNegotiation_A= On.)
Communication by Master.
Communication by Slave.
Time to wait for an interrupt for receiving
is specified (micro seconds). (*5)
Time to wait for an interrupt for
transmitting is specified (micro seconds).
(*5)
The number of buffer descriptor to wait
for an interrupt for receiving is specified.
(*5)