Fujitsu PCI Gigabit Ethernet User Manual page 65

No Message
15 DETACH failed ([detail])
16 failed to allocate([detail])
17 ddi_dma_alloc_handle failed([detail])
18 ddi_dma_addr_bind_handle failed([detail])
19 (Other messages)
Table A.3 Console Messages from the FUJITSU PCI GigabitEthernet Driver
No Message
1 network connection down
network connection up using portA
autonegotiation:[A]
speed: [B]
2
flowctrl: [C]
duplex mode: [D]
(role: [E]) (*1)
Cause
Unloading of the driver failed.
Allocating of the memory
resource failed.
Allocating of the DMA
resource failed.
There is a possibility of driver
internal bug or hardware
failure.
Cause
Link is down
Link has become up
[A]
yes: Auto-Negotiation is on
no: Auto-Negotiation is off
[B]
1000: Transmitting and
receiving data at 1000Mbps
100: Transmitting and
receiving data at 100Mbps
10: Transmitting and receiving
data at 10Mbps
[C]
symmetric: Send/accept
Flowcontrol requests to/from
the remote device.
remote send: Does not send
Flowcontol request. Only
accept Flowcontrol requests
from the remote device.
local send: Only send
Flowcontrol requests. Does not
accept Flowcontrol requests
from the remote device.
none: Disabled
[D]
full: Transmitting and receiving
data in full duplex mode
half: Transmitting and
receiving data in half duplex
mode
[E]
- 59 -
Workaround
After disabling the driver, re-do the
process (disconnect in Dynamic
Reconfiguration, etc.) If this message is
still displayed, report to your service
provider.
Installed physical memory may be
insufficient. If this is not the cause, report
this error to your service provider.
Report the error to your service provider.
Workaround
Check the cable connection and the
switch configuration.
There is no problem.