Asus RAMPAGE IV GENE User Manual page 86

The actual performance boost may vary depending on your CPU specification.
CPU Current Capability [Auto]
This item provides wider total power range for overclocking. A higher value brings a
wider total power range and extends the overclocking frequency range simultaneously.
Configuration options: [Auto] [100%] [110%] [120%] [130%] [140%] [150%] [160%]
[170%] [180%] [Disabled]
CPU Voltage Frequency [Auto]
Switching frequency will affect the transient response and component thermal. Higher
frequency gets quicker transient response.
Configuration options: [Auto] [Manual]
VRM Over Temperature Protection [Auto]
This item allows you to enable or disable the VRM over temperature protection.
Configuration options: [Auto] [Disabled]
CPU Power Duty Control [T.Probe]
[T.Probe]
[Extreme] Maintains the VRM current balance.
Vcore MOS volt. Control [Auto]
Configuration options: [Auto] [6V] [6.5V] [7V] [7.5V] [8V] [8.5V] [9V] [9.5V] [10V]
CPU Power Phase Control [Auto]
Phase number is the number of working VRM phase. Increasing phase number under
heavy system loading to get more transient and better thermal performance. Reducing
phase number under light system loading to increase VRM efficiency
[Auto]
[Standard]
[Optimized]
[Extreme]
[Manual Adjustment]
CPU Spread Spectrum [Disabled]
Configuration options: [Disabled] [Enabled]
CPU VCore Bootup Voltage [Auto]
This item controls the voltage for CPU at initial boot. Set higher value for better
overclockability. The values range from 0.800V to 1.990V with a 0.005V interval.
CPU VSA
VCCSA Load-line calibration [Auto]
The behavior of the DRAM controller is decided by VCCSA Load-Line. Set to a higher
value for system performance, or to a lower value for better thermal solution.
Configuration options: [Auto] [Regular] [High] [Extreme]
3-12
Maintains the VRM thermal balance.
The default power control phase mode
Proceeds phase control depending on the CPU loading.
Loads the ASUS optimized phase tuning profile.
Proceeds the full phase mode.
Allows manual adjustment.
Chapter 3: BIOS setup