Asus RAMPAGE IV GENE User Manual page 50

3. ASMedia
®
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
•
•
•
2-24
Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_E1/E2 [red])
The SATA6G_E1/E2 (red) connectors are for data drives only. ATAPI device is not
supported.
You must install Windows ®
hard disk drives.
When using NCQ, set the ASM1061 Storage Controller item in the BIOS to [Enabled].
Refer to section 3.5.6 Onboard Devices Configuration for details.
XP Service Pack 3 or later versions before using Serial ATA
Chapter 2: Hardware information