Installing The Power Supply; Finishing Up - TYAN S7016 User Manual

2.12 - Installing the Power Supply

There are three power connectors on your S7016. The S7016 requires 3 power
inputs.
- 24-pin (PW1)
- 8-pin (PW2, PW3)
1 x 24-pin 12V Power Connector (PW1)
2 x 8-pin 12V Power Connector (PW2, PW3)
NOTE: Please be aware that ATX 2.x, ATX12V and ATXGES power supplies may
not be compatible with the board and can damage the motherboard and/or CPU(s).
Applying power to the board:
1. Connect the 12V 8-pin power connector.
2. Connect the EPS/12V 24-pin power connector.
3. Connect power cable to power supply and power outlet.
YOU MUST unplug the power supply before plugging the power
NOTE
cables to motherboard connectors.

2.13 - Finishing up

Congratulations on making it this far! You're finished setting up the hardware
aspect of your computer. Before closing up your chassis, make sure that all
cables and wires are connected properly, especially IDE cables and most
importantly, jumpers. You may have difficulty powering on your system if the
motherboard jumpers are not set correctly.
In the rare circumstance that you have experienced difficulty, you can find help
by asking your vendor for assistance. If they are not available for assistance,
please find setup information and documentation online at our website or by
calling your vendor's support line.
34
http://www.tyan.com